Dowels

Dowels

Bonus | It is a hammered dowel in various lengths with plastic or steel nails for the mechanical assembly of the jacket heat insulation plates. Different dowels are used according to the wall type, thickness and material type. When the thickness of the insulation board increases too much, it is necessary to use nails (dowels) with a wide head but plastic coated steel body.

Dowel length 3 - 3.5 cm from the full application surface. should be selected to enter. On the perforated application surface, the tip of the dowel is 5 cm from the application surface. should be selected to enter. Dowel head 60 mm. should be. Dowels should be used in accordance with the insulation thickness and density to be used in exterior heat insulation applications, the wall structure where the application will be made is also important together with the insulation thickness.

The dowels used must be made of plastic. Dowel length should be "Plate thickness + Adhesive thickness + minimum 3 cm Surface Connection". Drill diameter on solid application surfaces ( exposed concrete ) is at least 1 mm from the diameter of the dowel. must be large. (10 mm dowel, 11-12 mm. drill) If the drill diameter is the same as the dowel, the dowel cannot open on the filled application surface.

The insulation thickness and the holding area of ​​the surface should be well calculated on the surfaces applied with cavities and an appropriate size dowel should be used.